Mecpow CUT-50, 50 A découpeur plasma, basse fréquence, coupes nettes 10 mm, coupe de sectionnement 15 mm, onduleur IGBT, double tension 110 V/220 V, démarrage par contact, ventilateur intelligent

Q: Why does the power indicator light up, but the fan isn’t working and the controls are unresponsive?

A: This usually happens when the overvoltage protection is triggered. Try turning off the machine, waiting for a few minutes, and then restarting it. 

Q: The machine powers on and runs, but it won’t initiate the arc. What could cause this?

A: There are two possible reasons for this issue: either the input voltage is too low, or the air compressor pressure is either too high or too low. If you're still unable to resolve the problem, please feel free to contact our professional customer service team for assistance!

Q: What is the maximum material thickness this cutter can handle? 

A: The plasma cutter can handle materials from 5 mm to 15 mm thick. For clean and precise cuts, it is recommended to use it on materials up to 15 mm thick.

Q: What materials can I cut with this plasma cutter?

A: MecpowCUT-50 plasma cutter is suitable for a variety of materials, including alloy steel, stainless steel, low-carbon steel, copper, aluminum, etc.

Q: Is it difficult to set up and start using the cutter? 

A: Not at all! The cutter comes with a plug-and-play air connector and a built-in regulator, allowing you to start cutting in just 30 seconds. 

Q: How accurate is the LED display? Can I read it while wearing a helmet? 

A: The large LED display provides precise and clear data readings, and it’s designed to be easily readable even while wearing a welding helmet. 

Q: How portable is this plasma cutter? 

A: This plasma cutter is only 5.2 kg; it is lightweight and compact, making it easy to transport between job sites or use at home. 

Q: Can I adjust the cutting time? 

A: Yes, you can set the cutting time between 5-15 seconds by 2T modes to suit your cutting preferences and comfort.

Q: What is the recommended air pressure for operation? 

A: The recommended air pressure is between 20-50 psi.